I'm using PTC Creo Parametric 3.0 M010 (The trial verision) and I've been going through the tutorials, but everytime I try to add a part to an assembly the program does a full crash with no explanation.
I've found a partial way around it by using the Assemble->Include rather than straight Assemble, but then I can't actually constrain it.
My video card is fully updated and I can't continue with the tutorials without this being fixed, so I'm hoping someone has the answer. The only other clue I have was I was also crashing whenever I tried to place a hole, which I solved by turning off preview, that's about all I've got clue-wise though.
Also, not sure if this is the right place to ask this question (New to Creo), but after holding for an hour and not getting to the first stage of tech support, I'm not sure if I can handle doing that again.
