Re: High local stress at inside corner
I guess you have to create a material with those properties at least. http://help.ptc.com/creo_hc/creo30_pma_hc/usascii/index.html#page/pma/simulate/modstr/props/reference/elastoplastic.html Not sure...
View ArticleRe: Mathcad Prime 3.1
Basically, PTC is choosing to rewrite the entire codebase of Mathcad over six or more version releases. Until a feature's code is rewritten, the feature remains unavailable in Prime. I guess the...
View Articlewhere is the Shaft feature in Creo 2.0
Insert > Advanced > Shaft in ProE Wildfire 5 for the On Point placement option.I wonder where it is in Creo 2.0Thanks
View Articlehow to switch over to different templates in schematics?
Hi Team, where Can I check which template used for that design and how to switch over the templates? Thanks,Madhu
View ArticleRe: where is the Shaft feature in Creo 2.0
It's not in the ribbon. You need to customize the ribbon (look under "Commands Not in the Ribbon") or to use the command search tool
View ArticleRe: where is the Shaft feature in Creo 2.0
OK, I found Shaft by seach, but I don't know how to add it to Customize Ribbon. Thanks
View Articlehow to edit/add artifacts of central library schematics?
Hi team, could you please answer how to add new artifacts to central library.
View ArticleRe: Drawings & embedded formats
It is a problem with where you store your formats and how you set the default format location. The systems seems to always look in the default format location. Maybe in the working folder 1st and the...
View ArticleRe: Windchill Installation - Load Balancer
Settting up the cluster as a whole is covered by the documentation for the Windchill version in question. Selecting a load balancer and configuring it are up to you, however. The underlying...
View ArticleRe: Windchill Installation - Load Balancer
P.S. As for setting up the cluster itself, this is much easier with Windchill 10.2 than previous releases (and somewhat different from previous releases as well as a consequence).
View ArticleRe: Drawings & embedded formats
I like to think of the format and the drawing as laying on top of each other transparently. Items on the format will "show through" to the drawing. Since the actual format is being loaded every time...
View ArticleRe: How to assemble to Sheet Metal Holes
We'll see... Support has already filed my error as SPR 2242012. I filed it as a high severity case. Just about anything I change in my file will cause the points to revert to projecting from the...
View ArticleRe: cosmetic sketch
The newer version of the feature is the same as the legacy. Just a different interface. I do not think we lost any functionality. However, you should be able to edit the older feature and it will...
View ArticleUnwanted regenerations
We are running Creo 2.0, just updated from WF5. It seems to regenerate far more often than previously experienced. When working on a model in insert mode, when I resume the next feature or features,...
View ArticleClik here to view.
Re: unable to make flat part
This one has a little refinement on the bend reliefs by creating the rounds before the shell.
View ArticleRe: Unwanted regenerations
Welcome to the forum, Phong. I am going to suggest that you have some very intricate dependencies between the part models and the assemblies. There is no reason for a part to regenerate unless top...
View Article